Update: UltraVNC 1.4.3.6 and UltraVNC SC 1.4.3.6: viewtopic.php?t=37885
Important: Please update to latest version before to create a reply, a topic or an issue: viewtopic.php?t=37864

Join us on social networks and share our announcements:
- Website: https://uvnc.com/
- GitHub: https://github.com/ultravnc
- Mastodon: https://mastodon.social/@ultravnc
- Facebook: https://www.facebook.com/ultravnc1
- X/Twitter: https://twitter.com/ultravnc1
- Reddit community: https://www.reddit.com/r/ultravnc
- OpenHub: https://openhub.net/p/ultravnc

SC Vista/7/2008 Session 0 isolation

Single Click discussions / bugs
Post Reply
AJSHG
Posts: 1
Joined: 2012-04-25 08:41

SC Vista/7/2008 Session 0 isolation

Post by AJSHG »

Hi there,

I spend now the last two days to figure out if SC works on session 0 isolation.

My SC works fine up to this point I come to switch to session 0. The Host PC switch to session 0 and there you have press “back” before I can take over the system again.

The reason I need to use SC is, these are servers and I can’t do any kind of port forwarding or firewall settings on this systems.

This is a need to take over session 0, the program we need to support is running in session 0 (starting as service).

My question now is:

Are there some Parameter to set in helptext.txt or need I to install SC as Service or what else to take over session 0?

I use SC 2011 and UVNC x64 1.0.9.6.2 ( tired with version before, the same)

Thanks in advanced

AJ
Post Reply