i want to connect a uvnc client to uvnc server by a batch file and disconnect the connection also by a batch file.
The Batch to connect is on the client pc and this is working.
The Batch file for the disconnection is on the server (remote) PC. The comand -kill stops the server and disconnect the connection, but I must start the server again to connect the client again. For sure, it is possible to start the service again by a batch. But this takes some seconds.
But i think it should be possible, to disconnect the client without stopping the server.
Has someone an idea, how can i do that?
If I use the tight VNC, there is a comand -disconnectall. This comand doesn't stop the server. But I can't swap to tight vnc. I have to use ultra vnc.
Thanks for your help!!!