Update: UltraVNC 1.4.3.6 and UltraVNC SC 1.4.3.6: viewtopic.php?t=37885
Important: Please update to latest version before to create a reply, a topic or an issue: viewtopic.php?t=37864

Join us on social networks and share our announcements:
- Website: https://uvnc.com/
- GitHub: https://github.com/ultravnc
- Mastodon: https://mastodon.social/@ultravnc
- Facebook: https://www.facebook.com/ultravnc1
- X/Twitter: https://twitter.com/ultravnc1
- Reddit community: https://www.reddit.com/r/ultravnc
- OpenHub: https://openhub.net/p/ultravnc

Viewer does not close connection correct

Post Reply
olest
Posts: 3
Joined: 2008-04-14 18:49

Viewer does not close connection correct

Post by olest »

The viewer does not seem to close the connection correct when it has not been connected to a server. E.g. click on start and then stop without having had a server connection.

The problem is that the Linux repeater does not detect that the viewer has disconnected.

The same scenario works fine with the server connecting and disconnecting without having had a viewer connection.
olest
Posts: 3
Joined: 2008-04-14 18:49

Re: Viewer does not close connection correct

Post by olest »

After some tests I have discovered that the viewer not disconnect correct before after 300 seconds (viewer idle timeout).
Last edited by olest on 2008-04-17 18:18, edited 1 time in total.
olest
Posts: 3
Joined: 2008-04-14 18:49

Re: Viewer does not close connection correct

Post by olest »

If I toggle debug I get the following at disconnect:

Socket error read, error code 10004
A blocking operation was interrupted by a call to WSACancelBlockingCall

But only with the linux repeater i think.
Post Reply