Connection Error using DSM plugin

[Indiana]

Hi all!
I'd been using VNC a lot for the last few years and never got any problems i couldnt solve but this one i had while trying to enable encryption plugin in order to setup a secure conection using UltraVNC-SC.

Scenario
- PC1 Runs VNCViewer in listening mode on port 5500 by the following start command:
vncviewer.exe -listen -dsmplugin MSRC4Plugin.dsm
- PC2 runs ultraVNC-SC for Rel1.00.
- UltraVNC-SC [host] section inside helpdesk.txt file:
[HOST]
Test 128bits encryption
-plugin -connect X.X.X.X:5500 -noregistry

- 128bits rc4.key and MSRC4Plugin.dsm files are the same on both PCs

When PC2 calls PC1 the result is :
Connection failed - Error reading Protocol Version
Possible causes:
- You've forgotten to select a DSMPlugin and the Server used a DSMPlugin
- Viewer and Server are not compatible (they use a different RFB protocoles) << misstypo?o.O

Can u guys tell what am I doing wrong?

Tx in advance.
Cheers

[redge]

build of msrc4plugin ?
you should use MSRC4plugin 1.2.2.0

[bevtech]

Also make sure when creating the exe that you use
Rudi

The creator based on rel1.00 allow defaults to be overwritten.

[Indiana]

ya, right there, it was the version of the msrc4plugin i had 1.2.0.0

the following works great:
UltraVNC ServerSC 20.03(Rel1.00)
UltraVNC Viewer 1.0.2
MSRC4Plugin: 1.1.6.0

you should use MSRC4plugin 1.2.2.0

ya, ill do that


tx all!