Setting a password??

gunsmoke · Post by **gunsmoke** » 2009-12-19 16:18

Hi guys

Is there a way to set a password while using single click?

How i would like it to be is, when i send the sc file to the person I'm trying to help, they would need to enter a password "that i set" before i can connect to them.

Thanks

redge · Post by **redge** » 2009-12-20 12:21

gunsmoke · Post by **gunsmoke** » 2009-12-20 18:56

Its ok I've managed to work it out myself

Thanks anyway

redge · Post by **redge** » 2009-12-20 19:55

solution for community ?

gunsmoke · Post by **gunsmoke** » 2009-12-20 20:56

redge wrote:solution for community ?

Sorry i should have explained how i did it

All i did was extract the SC exe edited it a bit and re compiled it again, only this time with a AES password request.

So how it works now is. i send the file to the person i want to help, then when they double click SC exe, they get a pop up window asking for the password before it will extract.

Hope this helps

redge · Post by **redge** » 2009-12-20 21:04

gunsmoke wrote: All i did was extract the SC exe edited it a bit and re compiled it again, only this time with a AES password request

i think is not SC from uvnc but an vnc related product ?

gunsmoke · Post by **gunsmoke** » 2009-12-20 21:28

redge wrote:
i think is not SC from uvnc but an vnc related product ?

No its the sc exe file you get from here: http://www.uvnc.com/pchelpware/sc/creator.html

UltraVNC

Setting a password??

Setting a password??

Re: Setting a password??

Re: Setting a password??

Re: Setting a password??

Re: Setting a password??

Re: Setting a password??

Re: Setting a password??